爐溫檢測系統的設計.docx
約37頁DOCX格式手機打開展開
爐溫檢測系統的設計,摘要本檢測系統硬件設計以at89c51單片機為核心,對6通道爐溫進行檢測、存儲,并具有傳感器故障報警及等功能。用新型的鉑電阻傳感器代替?zhèn)鹘y(tǒng)了sdram,使系統對采集數據存儲的可靠性得到保障。整個檢測系統硬件包括兩大部分電路,一部分是單片機系統,包括微控制器、a/d轉換、采樣保持器、通信模塊、鐵電存儲電路;另外一部分包括...
內容介紹
此文檔由會員 movingwlkk 發布
摘要
本檢測系統硬件設計以AT89C51單片機為核心,對6通道爐溫進行檢測、存儲,并具有傳感器故障報警及等功能。用新型的鉑電阻傳感器代替?zhèn)鹘y(tǒng)了SDRAM,使系統對采集數據存儲的可靠性得到保障。整個檢測系統硬件包括兩大部分電路,一部分是單片機系統,包括微控制器、A/D轉換、采樣保持器、通信模塊、鐵電存儲電路;另外一部分包括信號調理及放大電路、電源模塊等電路。單片機為系統的核心部分。六路傳感器分別將產生的溫度傳感器信號由信號調理電路進行調理之后再由多路開關循環送入A/D轉換器,再由單片機處理來自A/D轉換器的數據。
關鍵詞:單片機 傳感器 溫度檢測
Abstract
The hardware design of this measure system concentrates on AT89C51 microcontrotler to test and storage the surface temperature of workpiece in the oven and temperature of oven in the six channels. And it is provided with giving an alarm when there is a malfunction in the sensors or batteries lack of electricity capacity. Replacing conventional SDRAM with new type ferroclectric memory, this system can get a guarantee on reliability of gathering data and storage. It is very easy and useful. The entire detection system hardware, including two major circuits, in part, single-chip systems, including micro-controller, A / D converter, sample-and-hold, and watchdog, communications module, fcrroclectric memory circuit; others, including signal conditioning and amplification circuits, power modules and other circuitry Single-chip core of the system. Six sensors, respectively, will have a signal from the temperature sensor signal conditioning circuits, and then by the multi-channel switching cycle into the A/D converter, and then single-chip processing from A / D converter data.
Key words:Single-chipmicro computer Sensor Temperature detection.
目錄
摘要 Ⅰ
Abstract Ⅱ
第1章緒論 1
1.1 課題研究的目的和意義 1
1.2 爐溫檢測技術發展現狀 3
1.3 本文設計要求及性能指標 4
第2章 爐溫檢測系統的硬件設計 6
2.1 系統總體框圖的設計 6
2.2 單片機的選擇 7
2.2.1 AT89C51介紹 7
2.2.2 單片機最小系統 8
2.3 信號調理放大電路的選擇 9
2.3.1 傳感器的選擇 9
2.3.2 調理放大電路 10
2.4 多路選擇開關的設計 11
2.5 A/D轉換電路的設計 13
2.6 LED顯示電路的設計 13
2.7 存儲電路的設計 15
2.8 通信電路的設計 16
第3章 系統軟件的設計 17
3.1 主程序的設計 17
3.2 數據采集模塊的設計. 19
3.3 顯示程序的設計 21
結論 24
致謝 25
參考文獻 26
附錄Ⅰ 27
本檢測系統硬件設計以AT89C51單片機為核心,對6通道爐溫進行檢測、存儲,并具有傳感器故障報警及等功能。用新型的鉑電阻傳感器代替?zhèn)鹘y(tǒng)了SDRAM,使系統對采集數據存儲的可靠性得到保障。整個檢測系統硬件包括兩大部分電路,一部分是單片機系統,包括微控制器、A/D轉換、采樣保持器、通信模塊、鐵電存儲電路;另外一部分包括信號調理及放大電路、電源模塊等電路。單片機為系統的核心部分。六路傳感器分別將產生的溫度傳感器信號由信號調理電路進行調理之后再由多路開關循環送入A/D轉換器,再由單片機處理來自A/D轉換器的數據。
關鍵詞:單片機 傳感器 溫度檢測
Abstract
The hardware design of this measure system concentrates on AT89C51 microcontrotler to test and storage the surface temperature of workpiece in the oven and temperature of oven in the six channels. And it is provided with giving an alarm when there is a malfunction in the sensors or batteries lack of electricity capacity. Replacing conventional SDRAM with new type ferroclectric memory, this system can get a guarantee on reliability of gathering data and storage. It is very easy and useful. The entire detection system hardware, including two major circuits, in part, single-chip systems, including micro-controller, A / D converter, sample-and-hold, and watchdog, communications module, fcrroclectric memory circuit; others, including signal conditioning and amplification circuits, power modules and other circuitry Single-chip core of the system. Six sensors, respectively, will have a signal from the temperature sensor signal conditioning circuits, and then by the multi-channel switching cycle into the A/D converter, and then single-chip processing from A / D converter data.
Key words:Single-chipmicro computer Sensor Temperature detection.
目錄
摘要 Ⅰ
Abstract Ⅱ
第1章緒論 1
1.1 課題研究的目的和意義 1
1.2 爐溫檢測技術發展現狀 3
1.3 本文設計要求及性能指標 4
第2章 爐溫檢測系統的硬件設計 6
2.1 系統總體框圖的設計 6
2.2 單片機的選擇 7
2.2.1 AT89C51介紹 7
2.2.2 單片機最小系統 8
2.3 信號調理放大電路的選擇 9
2.3.1 傳感器的選擇 9
2.3.2 調理放大電路 10
2.4 多路選擇開關的設計 11
2.5 A/D轉換電路的設計 13
2.6 LED顯示電路的設計 13
2.7 存儲電路的設計 15
2.8 通信電路的設計 16
第3章 系統軟件的設計 17
3.1 主程序的設計 17
3.2 數據采集模塊的設計. 19
3.3 顯示程序的設計 21
結論 24
致謝 25
參考文獻 26
附錄Ⅰ 27
TA們正在看...
- 2010年一級建造師考試《法律法規》.doc
- 2010年一級建造師考試《機電實務》.doc
- 2010年一級建造師考試《建設工程經濟》.doc
- 2010年一級建造師考試《建筑工程》.doc
- 2010年一級建造師考試《項目管理》.doc
- 北大光華管理學院金融學考研試題.doc
- 電大《管理學基捶綜合測試試題.doc
- 上海海洋大學管理學原理2009-2010學年第一學期期末...doc
- 氦質譜檢漏儀查漏原理及其應用.pdf
- 經濟管理學院學生分散實習申請書.doc