本片畢業論文是基于單片機的畢業論文論文內容詳盡，具體包括內容如下：

摘 要

隨著社會的發展，自動控制成為越來越多人們關注的焦點,自動調節電阻爐溫度系統也備受關注。其中微機及其應用已經成為高、新科學技術的重要內容和標志之一，它在國民經濟的各個領域正在發揮著引人注目的作用。微機控制的電阻爐溫度控制系統實際上就是一個自動控制系統，是一種能耗相對來說比較低的溫度控制系統。
本文采用AT89C51單片微機對電阻爐的加熱過程進行控制。使用熱電偶作為溫度傳感器把熱信號轉變成電信號，電信號再經過放大，經過模數轉換再輸入到CPU。溫度控制的原理是通過調整晶閘管的導通時間來調節加熱主回路的有效電壓,從而達到溫度控制的目的。系統由AT89C51單片機、溫度傳感器、A/D轉換器、鍵盤及顯示電路、晶閘管觸發電路等組成的控制器和被控對象電阻爐構成一個閉環控制系統。系統控制程序采用模塊化設計結構，主要包括主程序、T0中斷服務子程序、溫度采樣子程序、顯示子程序、溫度控制子程序等。系統采用過零觸發等技術，省去了傳統的D/A轉換元件，簡化了電路，并且提高了系統的可靠性。同時，系統可以實時控制電阻爐的實際溫度。
關鍵詞：熱電偶；晶閘管；單片機

 
Abstract

With the development of the society，the autocontrol becomes more and more important.Theautocontrolof the resistance furnace is highly anticipated.Microcomputer and its application has become one of the most important contents and signs in the field of High-scientific technology and new scientific technology, which plays an attractive role in every field in our national economy.As a matter of fact, Resistance Temperature Control System which is operated by microcomputer is an Intellectual Control System.In other words，it is a Temperature Control System which consumes less than others.
The AT89C51 single microcomputer is adopted to control the heating process of resistance，use as a temperature transducer to turn the heating single into electing single，enlarge the electrical single，transformed through simulate numbers，then input CPU. The principle of temperature control is to adjust and heat the effective voltage of the main circuit through regulate the diversified time of transistor，therefore，it carries out the purpose of controlling the temperature.System as controlled resistance makes up an cycle control system.Control procedure of system adopts the structure of designing module，including main procedure，subsiding of suspending serves and subsidiary of control calculation etc.System adopt A.C、passes through zero etc technologies，omit traditional D/A transform components，simplify the circuit，and improve the dependability of system.Meanwhile，system also can control the real temperature of resistance at the right moment.
Keywords：thermocouple；thyristor；Microcomputer
  目 錄

引言 1
1概述 2
1.1課題研究的背景及意義 2
1.2 國內外研究現狀 3
1.3本文的主要內容 4
2電阻爐溫度控制系統總體設計方案 5
2.1系統方案論證 5
2.2系統組成 6
3系統硬件設計 8
3.1單片機介紹 8
3.2 EEPROM存儲器的擴展 10
3.3溫度檢測電路 12
3.3.1熱電偶冷端溫度補償 13
3.3.2測量放大電路 15
3.3.3保護電路 16
3.4 A/D轉換電路設計 16
3.4.1 AD574芯片介紹 16
3.4.2 AD574與單片機的接口電路設計 19
3.4.3光電耦合放大器的設計 19
3.5鍵盤及顯示電路設計 21
3.5.1鍵盤接口電路設計 21
3.5.2顯示電路設計 23
3.6可控硅調功控溫 24
3.7晶閘管過零檢測與觸發電路 26
3.8掉電檢測電路 27
3.9電源電路 27
4系統軟件設計 29
4.1主程序設計 29
4.2定時中斷服務程序 31
4.3溫度采樣子程序 32
4.4溫度控制子程序 34
4.5顯示子程序 36
4.6 A/D轉換子程序 37
4.7鍵盤掃描子程序 38
5結論 41
致謝 42
參考文獻 43
附錄A譯文文獻 44
附錄B外文文獻 48
附錄C系統原理圖 55
附錄D程序 56