摘要

設計污水處理廠處理東城坊鎮生活污水，處理規模為2×104 m3/d，污水來源主要為生活污水和工業廢水。根據畢業設計的原始資料及設計對出水水質的要求，出水達到《城鎮污水處理廠污染物排放標準》（GB18918-2002）中的一級A標準，要求脫氮除磷，有四類工藝方法初步符合要求，即傳統活性污泥法、A/O和A/A/O法、氧化溝和SBR工藝，并經過比較最終確定使用氧化溝工藝。
本設計使用卡魯塞爾氧化溝，該污水處理廠工藝流程：進廠原水首先進入中格柵，再經污水提升泵提升后進入細格柵，去除較大的懸浮物，以減輕對后續處理物的負荷，然后進入平流式沉砂池，去除相對密度較大的無機顆粒，以免影響后續處理構筑物的正常運行，再進入?yún)捬醭睾涂斎麪栄趸瘻?，進行生物處理，接著進入二沉池，最后進入接觸消毒池，消毒處理，排入水體。剩余污泥經污泥提升泵提升至濃縮池，以降低污泥的含水率。使用該工藝出水水質好，脫氮效率高，前置厭氧池，達到很好的除磷效果，構筑物少，經處理后出水完全能夠達到要求標準。
關鍵詞：污水處理，卡魯塞爾氧化溝，脫氮除磷，污泥濃縮

 
Abstract

To design sewage treatment plant is to deal with the East Fang town domestic sewage, its processing scale is 2x104m3/d, the main sources of sewage wastewater is domestic sewage and industrial sewage. According to the graduation design of the original data and design of effluent water quality, the effluent can meet the "urban sewage treatment plant pollutant discharge standard" (GB18918-2002) in an A standard, and be required to removal the nitrogen and phosphorus, four kinds of technology methods is to initially meet the requirements, namely the traditional activated sludge method, A/O and A/A/O method, oxidation ditch technology and SBR, and after comparison, oxidation ditch technology is to be chosen ultimately.
Carrousel oxidation ditch is to be used, The process of sewage treatment plant: the raw water first enters into the grid, and then by sewage lifting pump lifts into fine grille, to removal larger suspension, in order to reduce the follow-up processing load, and then into horizontal flow grit chamber, removing the large relative density of inorganic particles, so as not to affect the follow-up treatment structures normal operation, then enters the anaerobic pool and Carrousel oxidation ditch, to conduct biological treatment, then enters the secondary sedimentation, finally enters into contact disinfection tank, disinfecting, into a river. Surplus sludge is sent to concentrated pool by sludge lift pump, to reduce the water content of the sludge. Using the process, the effluent water quality is good, high efficiency of nitrogen removal，anaerobic pool is on the front, achieving good removal effect, few structures, the treated water can reach the required standard.
Key words: sewage treatment, Carrousel oxidation ditch, nitrogen and phosphorus removal, sludge thickening

 
目錄
摘要 I
Abstract II
第一章  引言 1
1.1我國水處理現狀與發展 1
1.2設計概述 1
1.2.1主要任務與目標 1
1.2.2主要內容與基本要求 2
第二章  污水處理工藝方案選擇與確定 4
2.1工藝方案選擇原則 4
2.2污水處理工藝流程的確定 4
2.2.1城鎮污水處理廠的主要工藝 4
2.2.2可行性方案的確定 6
2.2.3工藝流程的確定 8
第三章  污水處理工藝設計計算 10
3.1格柵的設計 10
3.1.1中格柵的設計 11
3.1.2細格柵的設計 12
3.2污水提升泵房的設計 14
3.2.1設計流量的確定和設計揚程的估算 15
3.2.2選泵 15
3.2.3集水池容積計算 16
3.3平流式沉砂池的設計 16
3.3.1設計參數 17
3.3.2設計計算 17
3.4厭氧池的設計 19
3.4.1設計參數 19
3.4.2設計計算 20
3.5氧化溝的設計 21
3.5.1設計參數 22
3.5.2設計計算 22
3.6二沉池的設計 26
3.6.1設計參數 27
3.6.2設計計算 27
3.7接觸消毒池與加氯間的設計 29
3.7.1設計參數 29
3.7.2設計計算 29
第四章  污泥處理工藝設計計算 32
4.1污泥回流泵房的設計 32
4.1.1設計流量的確定和設計揚程的估算 32
4.1.2選泵 32
4.1.3污泥回流泵房尺寸 32
4.2剩余污泥泵房的設計 32
4.2.1設計流量的確定和設計揚程的估算 33
4.2.2選泵 33
4.2.3剩余污泥泵房尺寸 33
4.3污泥濃縮池的設計 33
4.3.1設計參數 34
4.3.2設計計算 34
4.4貯泥池及污泥泵 36
4.4.1設計參數 36
4.4.2設計計算 36
第五章  污水處理廠的平面布置與高程布置 38
5.1污水處理廠的平面布置 38
5.1.1各處理單元構筑物的平面布置 38
5.1.2管、渠的平面布置 38
5.1.3輔助構筑物 39
5.2污水處理廠的高程布置 39
5.2.1高程布置說明 39
5.2.2水頭損失計算 40
5.2.3高程確定 42
結論 43
參考文獻 44
致謝 45